Subject = engineering Description = Harley Engineering specialise in the design, manufacture and installation of welded and fabricated sheet metal products. Category = engineering
may be an inverted L shape, such as is usually used to hold up a shelf, or a rafter extension and its diagonal brace supporting an overhanging roof over a gable.If a site
machining
decorative
b
rack
et
is used in furniture and mantlepieces are called corbels
machining
, site
machining
, composite
machining
You can hang a shelf anywhere.Then either adjust the shelf's location to allow the shelf
b
rack
et
to be mounted into the site
machining
studs, or use molly bolts in spaces between studs
machining
, site
machining
, composite
machining
If its going to hold toiletries or spices or some kitchen gatgets, it probably isn't critical
machining
, site
machining
, composite
machining
If its for books or liquids, site
machining
such as laundry
product
s, mounting the
b
rack
et
into the studs is a must.Use a square or a level and a pencil to mark a vertical line where you want the center of each site
machining
shelf
b
rack
et
to be
machining
, site
machining
, composite
machining
Mount the first
b
rack
et
where you marked the bottom of the shelf
machining
, site
machining
, composite
machining
Position the
b
rack
et
so that it is centered on the vertical line and even, at site
machining
the top, with the short horizontal line
machining
, site
machining
, composite
machining
To mount the shelf
b
rack
et
to a stud, use wood screws long enough to penetrate more than an inch into the stud
machining
, site
machining
, composite
machining
2 screws site
machining
should be long enough in most cases
machining
, site
machining
, composite
machining
To use a molly bolt in a space between studs, mark the location of each hole in the shelf
b
rack
et
on the wall
machining
, site
machining
, composite
machining
Set site
machining
the
b
rack
et
aside and draw a cross-hair across each location mark
machining
, site
machining
, composite
machining
Then remove the bolt from each molly, insert it through one of the holes in the
b
rack
et
, and re-tighten it.Set the site
machining
shelf on top of the first
b
rack
et
and set your level on the shelf
machining
, site
machining
, composite
machining
Center a second
b
rack
et
on its vertical mark with the shelf resting on it
machining
, site
machining
, composite
machining
slide that
b
rack
et
site
machining
up and down the wall until the shelf is level
machining
, site
machining
, composite
machining
Mark the location of the
b
rack
et
holes on the wall, set the shelf and level aside, and mount this
b
rack
et
as you site
machining
did the first
machining
, site
machining
, composite
machining
Place the shelf, or the piece of wood, on top of both of the
b
rack
et
that are now installed
machining
, site
machining
, composite
machining
Position any remaining
b
rack
et
on their vertical marks, touching site
machining
the bottom of the shelf
machining
, site
machining
, composite
machining
Mark the wall for their screws or bolts, take the shelf down, and install the remaining
b
rack
et
s
machining
, site
machining
, composite
machining
Set it on top of all of the
b
rack
et
s site
machining
with its ends aligned with the pieces of masking tape
machining
, site
machining
, composite
machining
If the shelf is attached to the
b
rack
et
with screws, drill a small pilot hole partway through the shelf and drive the site
